Irf Member Renumber - HP FlexFabric 7900 Series Command Reference Manual

Default
IRF member priority is 1.
Views
System view
Predefined user roles
network-admin
Parameters
member-id: Specifies an IRF member ID. The value range for this argument is 1 to 4. However, the
specified IRF member ID can only be 1 or 2.
priority: Sets priority in the range of 1 to 32. The greater the priority value, the higher the priority. A
member with higher priority is more likely to be the master.
Usage guidelines
Change member priority assignment to affect the maser election result.
This command is available in IRF mode. The new priority setting takes effect at the next master election,
but it does not trigger master election.
To assign an IRF priority to a device in standalone mode, use the irf priority command.
Examples
# Set the priority of IRF member 2 to 32.
<Sysname> system-view
[Sysname] irf member 2 priority 32
Related commands
irf priority

irf member renumber

Use irf member renumber to change the member ID of a device in the IRF fabric.
Use undo irf member renumber to restore the previous IRF member ID of the device.
Syntax
irf member member-id renumber new-member-id
undo irf member member-id renumber
Default
In standalone mode, the device has no member ID.
In IRF mode, the device by default uses the member ID set by using the irf member command.
Views
System view
Predefined user roles
network-admin
Parameters
member-id: Specifies the current ID of an IRF member device. The ID can only be 1 or 2.
16