Table of Contents
Advertisement
OPERATION
The product must only be put into operation if no defects are found. It is crucial that any defective parts are
replaced before the product is used again. Check the safety equipment and the safe condition of the
product: Check all parts to make sure that they fit tightly. Check whether there are any visible defects:
DO NOT EXCEED THE EQUIPMENT MAXIMUM LOAD CAPACITY OF 23kg (50lb).
Before filling the hopper, familiarise yourself with the operation of this Spreader.
•
The Spreader is designed to be pushed at 3 miles per hour – brisk walking pace. The rate of walking will
affect the spread pattern and flow rate.
•
Move the Wing Nut attached to the stop bolt on the gauge to the relevant setting.
•
Start pushing the Spreader forward & pull the control lever back to the stop bolt, opening the feed-gate
hole at the bottom of the hopper.
•
If the Spreader does not spread evenly, ensure that the FRONT of the gearbox points towards the front of
the Spreader. The impellor must rotate clockwise.
•
Material which is stuck on the impellor blades will cause uneven spreading.
•
To stop spreading, push the gauge lever forward to close the feed-gate hole in the hopper.
•
Remove the agitator when using refined de-icing salt to reduce gearbox damage. Salt may corrode the
machine and reduce its working life. DO NOT USE ROCK SALT.
•
If fertiliser is accidentally deposited too heavily in a small area, soak the area thoroughly with a garden
hose or sprinkler to prevent burning the lawn.
•
When broadcasting weed control fertilizers, make sure the broadcast pattern does not hit
evergreen trees, flowers or shrubs.
•
Always use the rain cover in wet weather conditions to keep the hopper contents dry.
DANGER
broken parts, cracks, etc.
DANGER
Advertisement
Table of Contents
