Table of Contents
Advertisement
CLEANING INSTRUCTIONS
CAUTION
:
SHOCk HAzARD
Do NOT splash or pour water
into or over any control panel
or wiring.
CAUTION:
SHOCk HAzARD
Disconnect warmer from
electric power before cleaning
CAUTION:
BURN HAzARD
Allow warmer to cool
completely before cleaning.
DAILY CLEANING INSTRUCTIONS
PREPARATIONS: Turn main power switch to OFF. Allow warmer to
cool before proceeding.
Remove any insets, utinsils and/or inserts.
Drain or remove water from well..
Minimum - daily.
FREQUENCY:
Mild Detergent
TOOLS:
Solution: 10 Parts Warm Water to 4 Parts Vinegar
Plastic Scouring Pad
Clean Cloth or Sponge
Food-Grade Silicone Sealant
1.
Wipe entire unit down using a clean cloth or sponge and mild
detergent.
2.
Use a plastic scouring pad to remove any hardened food particles
or mineral deposits.
IMPORTANT: DO NOT use steel wool for cleaning.
3.
Rinse warmer thoroughly with a vinegar and water solution to
neutralize all detergent cleanser residue.
4.
Inspect warmer flange-to-counter seal. Reseal with food-grade
silicone sealant if necessary. Failure to do so may allow grease and
water to leak into insulation and heating element, causing a potential
fire and/or electric shock hazard.
5.
Clean the Stand-Pipe (drain/overflow assy) and insert using mild
detergnet and warm water.
6.
Install the Stand-Pipe & insert, add proper amount of water and
rinse the basin. Turn the main power switch ON and check for proper
operation.
Procedure Complete.
8
Advertisement
Table of Contents
