Motorola APX Series User Manual page 90

English
technician. Check with your dealer or system administrator
for more information.
The range of Bluetooth operation when using a MCW
accessory is 10 meters line-of-sight communication. This is
an unobstructed path between the location of the signal
transmitter (your radio) and the location of the receiver
(your device or accessory).
Obstacles that can cause an obstruction in the line-of-sight
include trees, buildings, mountains, cars, and others.
For high degree of reliability, Motorola Solutions
recommends to NOT separate the radio and the accessory.
At the fringe areas of reception, both voice and tone quality
will start to sound "garbled" or "broken". To correct this
problem, simply position the accessory and radio closer to
each other (within the 10 meter defined range) to re-
establish clear audio reception.
NOTICE:
Once a COTS headset is paired to your radio, it is
always connected. Therefore the battery life of the
accessory is aligned with the Talk Time power
consumption, not the Standby Time consumption.
Turn on the accessory. Then, place it close to the
radio aligning the Bluetooth Pairing Location
90
blue dot) on the radio to the Bluetooth Pairing
Location (a blue dot) on the accessory.
If the pairing process is successful, you hear an
incremental-pitched tone. The radio begins to
connect to the device.
If the pairing process fails, you hear a short, low-
pitched tone. The display shows PAIRFAIL. Repeat
this step.
The radio tries to establish connection with the device once
paired.
NOTICE:
If the connection fails within 6 seconds, you hear a
decremental-pitched tone to indicate that the device
is unpaired. The display shows <Device Type>
UNPAIRED. Repeat this step to re-initiate the pairing
process.
If the connection is successful, you hear an incremental-
pitched tone. The display shows <Device Type>
CONNCTED and the Bluetooth icon turns from
If the radio has the pairing record of the device and the
connection fails, you hear a short, low-pitched tone. The
(a
display shows <Device Type> CON FAIL.
to .