Responder Alert Sensors; Holster Sensor; Disabling The Sensor - Motorola APX Series User Manual

English

Responder Alert Sensors

Responder alert sensors allow the radio to send over-the-
air (OTA) notification when the radio receives the holster
sensor event.
To enable the feature, ensure that the GPS, Enhanced
Data, and Bluetooth feature of your radio is on and the
radio supports Bluetooth Low Energy (BT-LE).
You can disable the holster sensor temporarily or
permanently. This feature allows you to prevent one or all
events from being reported OTA.
This feature is enabled through Customer Programming
Software (CPS) configuration. Check with your dealer or
system administrator for more information on the
programming of this feature.

Holster Sensor

Holster sensor monitors the state of the holster and allows
the radio to send an over-the-air (OTA) notification
whenever a gun or a taser is pulled out of the holster or put
in the holster.
NOTICE:
Applicable for APX 7000 only.
96

Disabling the Sensor

This feature gives you an option to avoid sending the
sensor events to the system by disabling the sensors
temporarily or permanently.
NOTICE:
The feature is only applicable to holster sensor and
weapon fired sensor. Vest pierced sensor cannot be
disabled.
Disabling the Sensor Temporarily
Short-press the preprogrammed Sensor button to
activate the sensor timer.
The following scenarios affect the sensor state:
• If a gun or taser is removed from the holster
within the timer duration, the timer stops and
switches the sensor to disabled state. A tone
sounds and the radio displays Sensor Disable.