Removing And Reinstalling The Chassis Cover - Imagine communications Nexio AMP Gen-7 Series Hardware Manual

Nexio AMP® Gen-7
Use your thumb to push against the upper part of the hard drive handle. Push the hard drive into the
base until it clicks into place.

Removing and Reinstalling the Chassis Cover

You must remove the chassis cover before you can access the motherboard or replace components such
as power supplies or fans.
WARNING: Do not operate the server without the chassis cover in place.
The chassis cover must be in place to allow proper airflow and to
prevent overheating. You can remove the cover for a short period of
time without powering down, but be sure the replace the cover as soon
as possible.
Before You Open the Chassis
1. Close all of your applications and shut down Windows.
2. Turn off all peripheral devices connected to the device chassis.
3. Press the power button to power-off the system.
4. Unplug all power cords from the system or the wall outlets.
5. Disconnect all the cables and label them for easy identification.
6. Use a grounded wrist strap designed to prevent static discharge when handling components.
Removing the Chassis Cover
1. Use a Phillips screwdriver to remove the 2 chassis screws.
2. Press both release buttons (toward the front of the unit on the top) at the same time. This will
release the cover from the locked position.
3. Once the cover is released, slide the cover back.
4. Lift the cover up and off the chassis unit.
To replace the cover, reverse steps 1, 2, 3, and 4.
2014 Imagine Communications | All Rights Reserved
Removing and Reinstalling the Chassis Cover
Page 28 of 42