Installing The Outer Rails On The Rack - Imagine communications Nexio AMP Gen-7 Series Hardware Manual

Nexio AMP® Gen-7 Installing the Rail Assemblies
4. Repeat steps 1 through 4 for the inner rail on the other side of the chassis.

Installing the Outer Rails on the Rack

1. Press upward on the locking tab at the rear end of the middle rail.
2. Push the middle rail back into the outer rail.
3. Hang the hooks on the front of the outer rail onto the slots on the front of the rack. If necessary, use
screws to secure the outer rails to the rack.
2014 Imagine Communications | All Rights Reserved Page 20 of 42