Sony BRAVIA XBR KDL-46XBR10 Operating Instructions Manual page 19

2
Secure the monitor to the stand.
Use the optional hardware listed below (not supplied):
• M4 × 12 machine screw (screwed into the monitor's Table-Top Stand).
• A screw or similar (attach it to the TV stand).
• Rope or chain (strong enough to support the weight of the monitor). Make sure that there is
no excess slack in the rope or chain.
An alternative way to secure the monitor is with an optional Sony Support Belt Kit.
3
Anchor the monitor to the wall.
Remove two screws from the top-most wall-mount holes.
Use the hardware listed below (not supplied):
• Two M6 × 8 mm anchor bolts (screw into the top-most wall-mount holes located on the rear
of the monitor).
• Rope or chain (attach to one M6 anchor bolt).
• Wall-anchor (attach to the wall stud) strong enough to support the weight of the monitor
(pass the rope through the wall-anchor, then attach to the other M6 anchor bolt).
Anchor bolts
Wall-
mount
holes
• Contact Sony Customer Support to obtain the optional Support Belt Kit by providing your monitor
model name.
For United States call: 1-800-488-7669 or visit: www.sony.com/accessories
For Canada call: 1-877-899-7669
• Measure 2 provides minimal protection against the monitor toppling over. For further protection,
follow all three measures recommended above.
Screw hole on the Table-Top Stand
Rope
or
chain
M4 × 12
machine
screw
Screw
Wall-
anchor
19