Pre-Installation Requirements - AT&T Merlin 206 Manual

1. Check Voice Terminal Ports.
Plug a Merlin Voice Terminal (using a 34 Button Display Set is required) into each port to be used for
"Telephone Emulation" (TE).
When doing this check, use the Telephone Emulation Cable that will be connected to the Classic Mail to
verify that the cord is good. If the telephone does not work, replace the cord and repeat this check.
Verify that the ports are good. If the intercom light goes on and you get intercom dial tone when you lift the
handset the port is good.
If any voice terminal port is not functioning, notify the Merlin system owner before continuing with Classic Mail
installation.
Line key programming not possible. No pre-installation programming is required.
Note:
2 . Check all vacant Marlin Tel.Co. ports
Move an existing Public Network connection to a vacant Merlin Tel.Co. port.
Verify that the port is good by calling the telephone number for that line. If a working connection is made
the port is operational.
Repeat the previous steps for each vacant Tel.Co. port.
If all ports are good and have proceed with installation.
Note:
If any line port is not functioning, notify the Merlin system owner before proceeding with the
installation.
Classic Mail Installation Package - Page 13
Pre-Installation
Requirements
Merlin 206, 410 & 820 Basic
(No Feature Modules Installed)