Options And Accessories - GE AF-650 GP Design Manual

9 Options and Accessories

GE offers a wide range of options and accessories for AF-650 GP.
9.1.1 Mounting of Option Modules in Slot A
Slot A position is dedicated to Network options. For further information, see separate operating instructions.
9.1.2 Mounting of Option Modules in Slot B
The power to the frequency converter must be disconnected.
It is strongly recommended to make sure the parameter data is saved (i.e. by DCT10 software ) before option modules are inserted/removed from the drive.
• Remove the Keypad, the terminal cover, and the Keypad frame from the frequency converter.
• Fit the OPCxxx option card into slot B.
• Connect the control cables and relieve the cable by the enclosed cable strips.
* Remove the knock out in the extended Keypad frame, so that the option will fit under the extended Keypad frame.
• Fit the extended Keypad frame and terminal cover.
• Fit the Keypad or blind cover in the extended Keypad frame.
• Connect power to the frequency converter.
• Set up the input/output functions in the corresponding parameters, as mentioned in the section General Technical Data.
Unit Sizes 12, 13 and 23
AF-650 GP Design Guide
Unit Sizes 15, 21, 22, 24, 31, 32, 33 and 34
9
167