Parameters Of Transfer Pulse Mode; Setting Parameters Of Transfer Pulse Mode - Nepagene ELEPO21 Instruction Manual

5 Operating Instructions
5.2.4

Parameters of Transfer Pulse mode


Voltage
The voltage of the first Transfer Pulse (increments: 1V)

Pulse Length
The time duration of one Transfer Pulse in milliseconds (increments: 0.1ms)

Pulse Interval
The time interval between Transfer Pulses in milliseconds (increments: 0.1ms)

Number of Pulses
The number of Transfer Pulses

Polarity Switching
This function reverses the polarity of Transfer Pulses. When the "+" indicator of the Polarity selection
option in the Set Parameters frame is illuminated, it means that the polarity switching function is OFF.
When the "+/-"indicator of "the Polarity selection option is illuminated, it means that the polarity switching
function is ON. If the voltage, number of pulses and polarity switching (+/-) are programmed, the out put
Pulses will be as follows;
5.2.5

Setting parameters of Transfer Pulse mode


Setting Voltage, Pulse Length, Pulse Interval, Number of Pulses and Decay
Rate
The same as Poring Pulse mode. See "5.2.3. Setting parameters of Poring Pulse mode" on this manual.

Setting Polarity Switching
1
Select the Polarity Switching option in the Transfer Pulse frame in the Selection window by pressing ◄ ▴
▾ ▸ buttons.
5-4
Time