Section 4: Troubleshooting The H-1130; Troubleshooting The Electronic Governor System - Haybuster H-1130 Operating Instructions And Parts Reference

Section 4: Troubleshooting the H-1130

4.1 Troubleshooting the electronic governor system

1. When power is reaching the electronic governor the fuse light should be on. If this light fails to go on,
check the fuse, the battery connections, the wiring harness, and the indicator lamp.
2. Checking the TUB MODE operation of the electronic governor. With the engine and hydraulic systems
at operating temperature, and the tub drive control valve in the forward position, throttle the engine up to
PTO speed.
With the mode switch in the tub position, the tub should be rotating. The speed of the tub can be varied by rotating
the tub limit knob. The number of tub speed lights which are lit will vary with the setting of the tub limit knob. If the
number of tub speed lights lit varies as you rotate the tub limit knob, the manual portion of the controls are functioning
correctly. Proceed to step 3. If the manual portion is not working properly, proceed to trouble shooting table below.
H - 1 1 3 0 T U B G R I N D E R O P E R A T I N G I N S T R U C T I O N S
63