Haybuster H-1130 Operating Instructions And Parts Reference page 32

BEFORE OPERATING CHECKS
Before operating the H-1130 Tub Grinder, follow these instructions:
Read and understand the operator's manual.
q
Learn how to operate the controls properly. Do Not let anyone operate without instruction.
q
Know the machine's safety features and understand the safety precautions.
q
Be sure the machine is hitched properly to the tractor.
q
Be sure to lubricate all lubrication points. See lubrication chart, page 46.
q
Check for loose bolts.
q
Make sure machine is properly adjusted.
q
Check hydraulic oil level
q
Check hydraulic components for leaks or damage.
q
WARNING: Hydraulic fluid escaping under pressure can be almost invisible and can have sufficient
force to penetrate the skin. When searching for suspected leaks, use a piece of wood or cardboard rather
than your hands. If injured, seek medical attention immediately to prevent serious infection or reaction.
Visually examine rotor to see if any parts have excessive wear. These parts include shaft, plates, rods,
q
hammers and moveable plate.
Check screens and screen hold downs for wear and tightness.
q
Check installation and condition of hammers.
q
Visually examine rotor bearings and mounting bolts.
q
Check all bearings for wear.
q
Check chains and belts for proper tension and condition.
q
Make sure all shields and guards are in place.
q
Check condition of decals, replace if excessively worn.
q
Check lug nuts for correct tightness. Lug nust should be tightened to a minimum of 120 ft-lbs (17 Kg-M).
q
Check condition of tire rims.
q
Check tires for proper air pressure. 48 PSI ( 3.3 BAR)
q
Always grind with the machine and tractor stationary on level ground.
q
In cold weather, allow five minutes for the machine to warm up before grinding.
q
Start the machine and check the tub direction, speed control governor for proper operation.
q
Watch for unusual or excessive vibration. If any occur, immediately shut off the power. Check to see
q
what is wrong and correct it before starting the grinder again.
If grinding grain, be sure proper grain attachment is in place.
q
20 H - 1 1 3 0 T U B G R I N D E R O P E R A T I N G I N S T R U C T I O N S