Haybuster H-1130 Operating Instructions And Parts Reference page 73

4. Once "ZERO reference point" is reached,
scribe a line through both locknut face and
adapter face (Picture 2). Then continue to
tighten the locknut (Picture 3) by turning it
clockwise using hammer and drift or
spanner by the appropriate rotation angle
shown on Table 1. Proper mounting has
been achieved when the scribed line on the
locknut has rotated from the scribed line on
the adapter face by the angle shown on
Table 1. To reach the full rotation of the
locknut, the use of hammer blows onto
spanner or drift may be needed for proper
mounting.
5. a) Slide lockplate over shaft and align tang of
lockplate with slot in adapter sleeve.
b) Find a locknut hole that aligns with a lockplate
hole. If the closest locknut hole is beyond a
lockplate hole, then tighten, not loosen, the locknut
to meet a lockplate hole
c) Insert lockwasher and tighten button head screws
to lock assembly. (Ref. Picture 4)
6. Bolt down pillow block or flange unit to the structure.
7. Repeat steps 1 through 6 for the expansion bearing except immediately after Step 2 do the
following:
EXPANSION
Pillow Blocks (Locknut facing outboard)
Align pillow block housing mounting holes with substructure mounting holes. Position insert in center of travel on rear
expanding bearing.
NOTE: This is necessary because in the process of mounting, bearing is being drawn toward locknut. Also
remember to keep weight off of bearing.
NOTE: Use hardened washers and properly tightened bolts to obtain sufficient clamp force between the
bearing block and the mounting structure.
H - 1 1 3 0 T U B G R I N D E R
Picture 2
Picture 3
Picture 4
O P E R A T I N G I N S T R U C T I O N S
61