Table of Contents
Advertisement
Watching the Picture
Input Signal, Picture Mode and
Display Status Information
Input signal and Picture Mode information appear on
the screen for about five seconds when the power is
turned on or when the input signal is switched.
To disable this function, follow the steps below.
1
In the CUSTOM SETUP menu, press M/m to
move the cursor (yellow) to "Display" and press
ENTER.
The following menu appears on the screen.
CUSTOM SETUP
Power Saving:
Standard
Speaker Out:
Off
Closed Caption:
Off
Display:
Off
Off
Color Matrix:
Y/PB/PR
On
HD Mode:
1080i
RGB Mode:
DTV
Sync Mode:
H/Comp
Illumination:
High
Remote
Select
Set
ENTER
2
Press M/m to set "Display" to "Off," then press
ENTER.
To display the information
Set "Display" to "On" in step 2 above, then press
ENTER. The factory default setting is "On."
Note
You can display the input signal information and the
time anytime by pressing the DISPLAY button on the
Remote Commander, regardless of the above setting.
22
(GB)
Exit
MENU
Advertisement
Table of Contents
