Using On-screen Menus
CUSTOM SETUP menu
You can reduce power consumption or set various
kinds of modes.
Reduces power consumption while showing pictures.
Standard: No energy saving
Reduce: Save energy
When you select "Reduce," the brightness of the
picture is reduced so that you can enjoy viewing
pictures while reducing power consumption.
• "Power Saving: Reduce" will be resumed when you
power on the unit again.
• Even when Power Saving is set to "Reduce", you can
still adjust the quality of the picture. However, note
that you may lose the energy saving effects if you
increase Contrast or Brightness.
Set it to ON to cause sound to be emmited from the
speakers SS-SP42FW/32FW (not supplied.)
Displays closed captions.
While using the combination of Component +
Component, you can display closed captions only for
input signals from the BKM-FW11 or BKM-FW12.
Off: The caption is not displayed.
CC1-4: Displays the caption superimposed on the
Select On to display the input signal information and
Picture Mode for about five seconds on the screen
when you turn on the unit or switch the input signal.
Sets the Color Matrix to show pictures in natural color
tones when a component signal is input.
For details, see "Adjusting Color Matrix" on page 36
Selects a mode according to an HD analog component
signal input to the display unit.
1080i: When a 1080i signal is input
1035i: When a 1035i signal is input
Sets the mode when a device that outputs RGB signals
is connected to the display unit.
DTV: When connected to an RGB signal digital
PC: When connected to a PC.
Sets the mode according to the signal input at pin 13
of the RGB/COMPONENT connector. Signals can be
set only to 575/50I or 480/60I.
H/Comp: When a horizontal signal or a composite
synchronous signal* is input
Video: When a video signal is input
*Depending on the level of the composite
synchronous signal, the image may not be displayed
correctly. In that case, change the Sync Mode
Input signal and Synchronous mode settings
Signal input over the D-sub
480/60I, 575/50I Composite Video
H Sync/V Sync
Sync On Green
See "Pin assignment" on page 42 (GB) for more
information on the pin assignments of RGB/COMPONENT
• There are some inputs for which only synchronizing
signals can be selected. In this case, an image will
not be displayed even if a video signal is input to the
13 pin connector. Input horizontal/vertical
synchronization signals through the 13 or 14 pin
connectors, or input Sync On Green signals through
the RGB connector.
• With Sync On Green, if the unit is not set to accept
synchronizing signals, the image will not be
• Signals of the synchronous mode can be supported
only with INPUT2.
• Sync Mode settings cannot be carried out for the
input through the option boards.
• This unit does not support the three value sync
format of composite sync and 576/60P.