Enter the password again for re-confirmation.
Re-enter new password key.
Be sure to remember this password.
Cancel : Other key
The setting is finished when the following
Auto Shut Off:
Security Lock enabled!
If "Invalid password!" appears on the menu
screen, start the procedure again from Step 1.
Auto Shut Off:
After completing the process described above,
turn off the display unit and unplug the power
cord to make the setting valid.
The Security Lock becomes activated and the
dialog box prompting you to enter the password
appears when you turn on the display unit next
Enter the password that is set for the display unit
when the dialog box prompting you to enter the
If you enter the wrong password three times, you
cannot operate the display unit any further. In this
situation, press the 1POWER switch to turn off the
Setting the Security Lock / Self-diagnosis Function
To deactivate the Security Lock
Press MENU and set "Security Lock" to "Off" in the
INITIAL SETUP/INFORMATION menu.
The unit has a self-diagnosis function.
This function shows the display's condition based on
the pattern shown by the flashing of the POWER/
STANDBY indicator. The flashing pattern informs
you of the display's current condition.
If the POWER/STANDBY indicator flashes, check
the number of flashes and contact your authorized
Check the flashing pattern of the POWER/
The indicator flashes (with an image showing on
the display) or flashes at intervals of three seconds
(with no image showing on the display).
Count the number of flashes if the indicator
flashes at intervals of three seconds. For example,
the indicator flashes twice, followed by a three
second pause, two more flashes and this pattern
repeats. In this case, the count for the number of
flashes is two.
Unplug the unit.
Inform your authorized Sony dealer of the number