Input Signal, Picture Mode And Display Status Information - Sony FWD-40LX1 Operating Instructions Manual

Watching the Picture
Input Signal, Picture Mode and
Display Status Information
Input signal and "Picture Mode" information appear
on the screen for about twenty seconds when the
power is turned on and for about five seconds when
the input signal is switched.
To disable this function, follow the steps below.
1
In the CUSTOM SETUP menu, press M/m to
move the cursor (yellow) to "Display" and press
ENTER.
The following menu appears on the screen.
CUSTOM SETUP
Power Saving: Standard
Speaker Out: Off
Closed Caption: Off
Display: Off Off
Color Matrix: Y/PB/PR On
HD Mode: 1080i
RGB Mode: DTV
Sync Mode: H/Comp
Illumination: High
Remote
Select Set ENTER
2
Press M/m to set "Display" to "Off," then press
ENTER.
To display the information
Set "Display" to "On" in step 2 above, then press
ENTER. The factory default setting is "On."
Note
You can display the input signal information and the
time anytime by pressing the DISPLAY button on the
Remote Commander, regardless of the above setting.
22
(GB)
Exit MENU