Download  Print this page

Connections; Connecting The Speakers; Connecting The Ac Power Cord; Attaching The Ferrite Cores - Sony 32LX1 Operating Instructions Manual

Sony operating instructions flat panel display.
Hide thumbs

Advertisement

Connections

Connections
Before you start
• First make sure that the power to each piece of
equipment is turned off.
• Use connecting cables suitable for the equipment to
be connected.
• The cable connectors should be fully inserted into
the jacks. A loose connection may cause hum and
other noise.
• To disconnect the cable, pull it out by grasping the
plug. Never pull the cable itself.
• Refer to the instruction manual of the equipment to
be connected.
• Insert the plug securely into the AC IN socket.
• Use one of the two AC plug holders (supplied) that
will securely hold the AC plug.

Connecting the Speakers

You can enjoy viewing with a greater sense of
presence by connecting speakers SS-SP42FW/32FW
(not supplied). Please be sure to connect the speakers
correctly. For more details on connecting the
speakers, see the operating manual that came with the
speakers.
For details on how to route the speaker cords, refer to
"Using the cable holders" on page 15 (GB).

Connecting the AC Power Cord

1
Plug the AC power cord into the AC IN socket.
Then, attach the AC plug holder (supplied) to the
AC power cord.
AC IN socket
2
Slide the AC plug holder over the cord until it
connects to the AC IN socket cover.
14
(GB)
To remove the AC power cord
After squeezing the AC plug holder and freeing it,
grasp the plug and pull out the AC power cord.

Attaching the ferrite cores

1
Attach the ferrite cores to the ends of the cable,
closing it until it clicks.
Within 10 mm (
2
Wind the stopper around the cable so that the
ferrite core does not slide.
Within 10 mm (
3
Tighten the stopper and cut the surplus.
AC power cord
AC plug holder
Notes
• When you connect a cable to any of the terminals
listed below, attach the ferrite cores provided before
using the cable.
AC IN socket
DVI-HDCP(INPUT1): Attach the ferrite cores to
cover
both ends of the cable as shown in the illustrations.
• You are cautioned that this unit will not be in
compliance with the EMC limits unless you attach
the ferrite cores on the interconnecting cable.
Within 10 mm (
13
/
inch)
32
Within 10 mm (
13
/
inch)
32
13
/
inch)
32
13
/
inch)
32

Advertisement

Table of Contents

   Related Manuals for Sony 32LX1

Comments to this Manuals

Symbols: 0
Latest comments:
  • Traci Jul 24, 2018 04:03:
    What if the light comes on but the screen stays black?