Table of Contents
Advertisement
Safety Instructions
General Safety
Instructions
ii
WARNING! All electrical installation and maintenance work on the
drive should be carried out by qualified electricians.
The drive and adjoining equipment must be properly earthed.
Do not attempt any work on a powered drive. After switching off the
mains, always allow the intermediate circuit capacitors 5 minutes to
discharge before working on the frequency converter, the motor or the
motor cable. It is good practice to check (with a voltage indicating
instrument) that the drive is in fact discharged before beginning work.
The motor cable terminals of the drive are at a dangerously high
voltage when mains power is applied, regardless of motor operation.
There can be dangerous voltages inside the drive from external control
circuits even when the drive mains power is shut off. Exercise
appropriate care when working with the unit. Neglecting these
instructions can cause physical injury and death.
WARNING! There are several automatic reset functions in the
drive. If selected, they reset the unit and resume operation after a fault.
These functions should not be selected if other equipment is not
compatible with this kind of operation, or dangerous situations can be
caused by such action.
More Warnings and Notes are printed at appropriate instances along
the text.
NCSA-01 Installation and Start-up Guide
Advertisement
Table of Contents
