Repeat Playback-Automatic Cyclical Playback; Setting Points A And B For Repeat Playback - Sony DSR-1800AP Operating Instructions Manual

Repeat Playback—Automatic Cyclical Playback

Setting Points A and B for Repeat Playback

Setting the current tape position as point A or B
40
Playback
Proceed as follows to perform automatic cyclical playback of recording (repeat
playback) between selected start and end points.
1
Set the desired repeat start and end points with the REPEAT FUNCTION
menu item (see page 62).
You can set points A and B as start and end points by following the
procedure described in the next section.
2
Set the REPEAT MODE menu item (see page 62) to ON.
The REPEAT indicator lights.
3
Press the SET (YES) button to save the new setting and close the menu.
4
Press the PLAY button.
The unit repeats playback between the repeat start and end points set in step
1.
You can set the repeat playback start point (point A) and end point (point B) by
using the current tape position or inputting time code values.
To perform repeat playback after setting points A and B, press the PLAY button
when the REMOTE button is off. When the DSRM-10 Remote Control Unit is
connected to the CONTROL S connector on the front panel, you can also start
repeat playback by pressing its PLAY button with the REMOTE button of this
unit off.
Proceed as follows to set the current tape position as point A or B for repeat
playback.
Buttons used for setting the
current tape position as
point B
In the following explanation of how to set points A and B for repeat
playback, these three buttons are referred to as the KA button, Bk
button, and SET (YES)
A B
MARK
MARK button, respectively.
Buttons used for
setting the current
tape position as
point A