Shock Sensor; Remote Operation - Prestige APS25Z Installation And Reference Manual

Detailed Descriptions: External Components & Opperation

Shock Sensor

The shock sensor plugs into a 4-pin connector on the Prestige module. It should be securely attached to a vehicle surface
or sturdy wire harness. Testing takes place after all connections are made and the system is powered up.
Reference: System Diagnostics on page 10
LED / Valet Programming Port
The LED / Valet Programming port is used to for feature programming and Valet Override.
1. Find a sutiable location to mount the supplied LED / Valet Programming button. Locate a clear spot on the vehicle's
dashboard that will be seen from the outside of the vehicle.
2. Drill a 5/16 inch hole and mount the LED / Valet button. Route the wires to module and plug into proper location.
Remote Control Operation
This system includes two (2) 1-Way three (3) button remotes. The matrix below describes the basic functions of each
remote. See Owners Guide for complete remote operation matrix.
Three Button Remotes (1-Way)
Valet Alarm Override
The Valet Override procedure will disable the alarm when the remote is not available or has become inoperative. If the
vehicle door is opened without disarming, the alarm will sound and the vehicle will not start when attempting to start
with the key. To disable the alarm:
1. Turn the vehicle ignition to ON.
2. Within 5sec, press and release valet button on Antenna 1x.
The alarm will silence and the vehicle will now start normally with the key.
4
for instructions on testing and adjusting the shock sensor.
Bu�on Ac�on
Press 1x
Hold 3 Seconds
Press 1x
Hold 3 Seconds
Press 2x
Hold 3 Seconds
Func�on
Lock
Panic ON/OFF
Unlock
Panic ON/OFF
No Func�on
Trunk Release
Refer to Quick
APS25Z_RevA_08/18