Input And Output Signals In 24P (23.98P) Mode - Sony PDW-F70 Operating Instructions Manual

OPERATIONAL FUNCTION
SYSTEM SEL
SYSTEM FREQ : 601
* 60I
50I
30P
25P
23.98P
14
Press the m/MARK2 button to select "23.98P".
15
If you want to change the monitor output setting as
well, press the </IN button to return to the higher
level screen (the state of step 11). If you do not want
to change the monitor output setting, proceed to step
19.
16
Press the m/MARK2 button to select "23.9P
OUTPUT".
17
Press the ,/OUT button.
The setting value appears.
OPERATIONAL FUNCTION
SYSTEM SEL
23.9P OUTPUT: PsF
* 23.98PsF
2-3 PULL DOWN
18
Press the M/MARK1 or m/MARK2 button to select
one of the following.
23.98PsF: Output as 23.98P.
2-3 PULL DOWN: Output after pulldown conversion
to 59.94i.
19
Press the SET button.
A confirmation message appears.
20
Press the SET button to confirm the changes, or the
RESET button to cancel them.
If you have pressed the SET button, power the unit off
and on again to enable the changes.
34
24P (23.98P) Mode Settings
SETUP MENU
SETUP MENU
Input and Output Signals in 24P
(23.98P) Mode
The following tables show the signals input and output by
the unit when "23.98PsF" and "2-3 PULL DOWN" are
selected.
Input and output signals
I/O Type 23.98PsF
Input Reference 23.98PsF
signals video input reference signal
HDSDI input 23.98PsF video and audio
signals
Input LTC input 24-frame timecode
timecode
HDSDI LTC
input
Output HDSDI 23.98PsF video
signals output and audio
signals
SDSDI output No output
Composite
output
i.LINK DV
output
i.LINK TS
output
Timecode LTC output 24-frame
output timecode
HDSDI LTC/
VITC output
SDSDI –
RP188 LTC
output
SDSDI VITC –
output
COMPOSITE –
VITC output
2-3 PULL
DOWN
59.94i
reference signal
Video and
audio signals
pulled down to
59.94i
30-frame
timecode after
pulldown
conversion