Editing Control Unit Settings; Remote Control Unit Settings; Using Xlr Cables (Audio Cables) - Sony PDW-F70 Operating Instructions Manual

To composite video input connector
To analog audio input connector
1
COMPOSITE AUDIO
OUT MONITOR
REF VIDEO INPUT COMPOSITE OUT AUDIO MONITOR
R L
AUDIO INPUT AUDIO OUTPUT
DIGITAL
AUDIO
1/3 2/4 1/3 2/4 (AES/EBU)
INPUT
OUTPUT
HDSDI INPUT HDSDI OUTPUT SDSDI OUTPUT
1 2
MONITOR
DSR-2000A/2000AP (recorder)
VIDEO OUT 3
(SUPER)
To composite
video input
connector
To analog audio input connector
SD video monitor
1: 75Ω coaxial cable (not supplied)
2: Phono plug – stereo miniplug cable (not supplied)
3: Phono plug cable (not supplied)
4: i.LINK cable (not supplied)
DSR-2000A/2000AP
(recorder) settings
i.LINK button: Lit
SDTI/i.LINK button: i.LINK Set the setup menu item
For details about the settings of the DSR-2000A/2000AP,
refer to the operating instructions for that unit.
SD video monitor
2
PDW-F70 (this unit, player)
TIME CODE
-
AC IN
IN OUT
POWER
ANALOG HD INPUT
Y/G P /R
B
1/2 3/4
P /B SYNS
B
1/2 3/4
RS232C REMOTE(9P)
S400
CONTROL
S400
4
i.LINK
MONITOR
AUDIO
1
3
This unit's (player) settings
Remote control switch:
REMOTE
INTERFACE SELECT
>REMOTE I/F to "i.LINK" (see
page 94).

Editing Control Unit Settings

When connecting an editing control unit to use with this
unit, make the following settings.
BVE-700/700A
Set VTR constants as follows.
System VTR CONSTANT 1
frequency
1 2 3
30P/60I A0 93 00
25P/50I A1 93 00
24P A2 93 00
System VTR CONSTANT 2
frequency
1 2 3
30P/60I 0A 07 FE
25P/50I 0A 07 FE
24P 0A 07 FE

Remote Control Unit Settings

You can control this unit from an RM-280 Remote Control
Unit.
Connect this unit to the RM-280 with a 9-pin remote
control cable (not supplied), and make the settings in the
following table.
RM-280 settings Settings on this unit
EDITOR/REMOTE Setup menu item INTERFACE
CONTROL: REMOTE
CONTROL
Setup menu item 19 Remote control switch: REMOTE
FNC MODE: XDCAM
Remote connector selector

Using XLR Cables (Audio Cables)

Before connecting XLR cables to this unit's analog audio
input and output connectors, always attach the supplied
ferrite cores to the XLR cables. Attach as shown below.
To attach the ferrite core
Loop the XLR cable one time through the ferrite core, on
the side closest to the connector that is connected to this
unit, and fix the ferrite core at the specified position.
4 5 6 7 8
96 16 16 03 80
7D 16 16 03 80
78 16 16 03 80
4 5 6 7 8
00 80 5A FF 5A
00 80 4C FF 4B
00 80 48 FF 48
SELECT >REMOTE I/F (see
page 94): 9PIN/RS-232C
switch: REMOTE(9P)
Connections and Settings
29