Safety Information - Fluke 113 Calibration Information Manual

113
Calibration Information

Safety Information

"Warning" and "Caution" Statements
A "Warning" identifies hazardous conditions and actions that could cause bodily harm or death.
A "Caution" identifies conditions and actions that could damage the Meter, the equipment under test, or cause
permanent loss of data.
To avoid possible electric shock or personal injury, follow these guidelines:
•
Use the Meter only as specified in this manual or the protection provided by
the Meter might be impaired.
•
Do not use the Meter or test leads if they appear damaged, or if the Meter is
not operating properly.
•
Always use proper terminals, switch position, and range for measurements.
•
Verify the Meter's operation by measuring a known voltage. If in doubt, have
the Meter serviced.
•
Do not apply more than the rated voltage, as marked on Meter, between
terminals or between any terminal and earth ground.
•
Use caution with voltages above 30 V ac rms, 42 V ac peak, or 60 V dc.
These voltages pose a shock hazard.
•
Disconnect circuit power and discharge all high-voltage capacitors before
testing resistance, continuity, diodes, or capacitance.
•
Do not use the Meter around explosive gas or vapor.
•
When using test leads or probes, keep your fingers behind the finger
guards.
•
Remove test leads from Meter before opening the battery door or Meter
case.
•
Comply with local and national safety requirements when working in
hazardous locations.
•
Use proper protective equipment, as required by local or national authorities
when working in hazardous areas.
•
Avoid working alone.
•
Check the test leads for continuity before use. Do not use if the readings are
high or noisy.
2
XWWarnings and Precautions