Advertisement
How to Install and Use the Oversized Standing Platform
If you ordered an Allegro Stretch Reformer, your machine
comes with the "New Style" Tilting Oversized Standing Platform
and Oversized Platform Pad. If you ordered a normal Allegro
Reformer, refer below to determine which Platform to order.
Determine which style of Allegro Reformer you have.
» If the rails near your trunion and standing platform have
a slotted hole, follow new style instructions and order part
number 950-266; Oversized Standing Platform, A1b.
» If your reformer does not have slots in the rails, please follow
the old style instructions (separate sheet) and order part
number 720-063; Oversized Standing Platform, A1b.
NEW STYLE
INSTALL THE OVERSIZED STANDING PLATFORM
1. Lower the Tilting Oversized Standing Platform (O.S.P) down
onto the mounted standing platform. There are two tabs on
the O.S.P. which will drop into slots in the standing platform.
The pins on the underside will be facing toward your carriage.
See Figure B.
2. Once the O.S.P. has the tabs installed, pivot it forward and
down so that the pins lower onto the rails and fall into the
slots in the rails. See Figure C.
3. You can now use your O.S.P. To access and change springs, tilt
the O.S.P. up and away from the carriage. When finished with
the change, lower the O.S.P. back down onto the rails.
26
Figure B
Figure C
Advertisement
