Surround Mode Settings - Sony DVP-LS785V Operating Instructions Manual

Surround Mode Settings

You can enjoy surround sounds while playing
discs including Dolby Digital, DTS, and
MPEG audio DVDs, even if you have only 2
or 4 speakers. Select the surround mode that
best suits your speaker setup.
1
Press SUR during playback.
The following display appears.
TVS DYNAMIC
2
Press SUR repeatedly to select
one of the surround modes.
See the explanations given for each item
in the following section.
For 2 speaker setups
• TVS DYNAMIC
• TVS WIDE
• TVS NIGHT
• TVS STANDARD
54
To cancel the setting
Select "OFF" in step 2.
For 2 speaker setups
When you connect a stereo TV or 2 front
speakers, TVS (TV Virtual Surround) lets
SUR
you enjoy surround sound effects by using
sound imaging to create virtual rear speakers
from the sound of the front speakers (L: left,
R: right) without using actual rear speakers.
TVS was developed by Sony to produce
surround sound for home use using just a
stereo TV.
If the player is set up to output the signal from
the DIGITAL OUT (OPTICAL or
COAXIAL) jack, the surround effect will be
heard only when "DOLBY DIGITAL" and
"DTS" are set to "D-PCM" and "MPEG" is
set to "PCM" in "AUDIO SETUP"(page 86).
Creates one set of virtual rear speakers from
the sound of the front speakers (L, R) without
using actual rear speakers (shown below).
This mode is effective when the distance
between the front L and R speakers is short,
such as with built-in speakers on a stereo TV.
Creates five sets of virtual rear speakers from
the sound of the front speakers (L, R) without
using actual rear speakers (shown below).
This mode is effective when the distance
between the front L and R speakers is short,
such as with built-in speakers on a stereo TV.
For 4 to 6 speaker setups
(If you select "NONE" in the setting of
"REAR" in "SPEAKER SETUP"
(page 87), you cannot select these
modes.)
• NORMAL SURROUND
• ENHANCED SURROUND
• VIRTUAL REAR SHIFT
• VIRTUAL MULTI REAR
• VIRTUAL MULTI DIMENSION
TVS DYNAMIC
TV
TVS WIDE