4.1 - 2
Typical Test Setup
Note: Check with your Motorola local representative for the availability of Cradle
FTN6308 required for this type of testing, it is part of Digital Car Kit FTN6307.
Carry out the following instructions before testing:
• Check that you have a fully charged battery (not required when using Battery
• Install the MTH800 into the FTN6308 Digital Car Kit cradle.
• Connect RF cable 3086228J02 to the N-type RF Connector of the IFR.
• Connect the other side of the RF cable to the cradle's RF connector.
MTH800
BATTERY
ELIMINATOR
(WALN4097)
MTH800 TETRA Handportable Terminal / Basic Service Manual
Eliminator WALN4097).
Figure 1. Typical Test Setup
IFR
FTN6308 CRADLE
3.8 V
POWER
SUPPLY
TEST SETUP & TESTING 380-430MHz
2968
N-TYPE
RF CONNECTOR
3086228J02
RF CABLE