TEST SETUP & TESTING 380-430MHz
Duplex Test
1. Digital Duplex Test (Tx)
Measurement Capabilities:
Bar charts (Tx Power, Freq. Err, Vector Rms.), Spectrum Analyser, Power
Analyser, Vector Analyser, Vector Diagrams
How to Configure the IFR 2968 Setup
Perform the following steps to configure the IFR 2968 with the terminal set:
1. Turn ON the IFR.
2. Press "Systems" Mode Key (wait until the digital system is initialised).
3. Press the "Tetra Mobile" softkey.
4. Press the "Setup" softkey and enter the System Parameters Screen.
5. Press the "Channel Plan" softkey.
6. Press "Tetra 410MS" softkey. The "Control Channel" automatically changes to
7. Press twice the "Traffic Channel" softkey and check that the marker goes to
8. Press "Country Code" softkey. Enter "753" and "Country Code" softkey.
9. Press "Network Code" softkey. Thereafter, enter "2361" and press "Network
10. Press "Base Color" softkey. Thereafter, enter "1" and press "Base Color"
11. Press "Location Area" softkey. Thereafter, enter "23" and press "Location
12. Press "More" softkey. Press "Min Rx Level" softkey. Thereafter, enter "-
13. Press "Max Tx Level" softkey. Thereafter, enter "30dBm" and press "Max Tx
14. Press "Access Parameter" softkey. Thereafter, enter "-53dBm" and press
15. Press "Base Service" softkey and "Supported" softkey
MTH800 TETRA Handportable Terminal / Basic Service Manual
"800"; and "Traffic Channel" automatically changes to 900.
Timeslot. Press Data key "3" followed by the "Traffic Channel" softkey, to
change to Timeslot "3".
Code" softkey.
softkey.
Area" softkey.
110dBm" and press "Min Rx Level" softkey.
Level" softkey.
"Access Parameter" softkey.
4.1 - 5