Motorola TETRA MTH800 Basic Service Manual page 53

TEST SETUP & TESTING 440-470MHz
12. Press any key again. The display shows "Display Backlight On" and the
13. Press any key again. The display shows "UCM Detected".
14. Press any key again. The display shows "UCM Power up Success".
15. Press any key again. The display shows "UCM Wake Up Success".
16. Press any key again. The display shows "UCM Ping Success".
17. Press any key again. The display shows "UCM Not Detected".
18. Press any key again. The display shows "Speaker Tone Test", a tone is heard
19. Press any key again. The display shows "Internal Earpiece Tone Test", a tone
20. Press any key again. The display shows "Connect PHF for the following
21. Press any key again. The display shows "PHF Earpiece Tone Test". A tone is
22. Press any key again. The display shows "Connect RSM-CE for the following
23. Press any key again. The display shows "RSM-CE Connector Tone Test". A
24. Press any key again. The display shows "INT MIC to INT EAR Loopback
25. Press any key again. The display shows "Connect PHF for the following
26. Press any key again. The display shows "TOP Mic to PHF EAR Loopback
27. Press any key again. The display shows "PHF Mic to PHF EAR Loopback
28. Press any key again. The display shows "Connect RSM-CE for the following
MTH800 TETRA Handportable Terminal / Basic Service Manual
display backlight is On.
Note: The following readings appears only when a Universal Crypto Module
(UCM) board is installed in the unit.
Note: The following reading appears only when a UCM board is not installed
in the unit.
via the speaker.
is heard via the internal earpiece.
Tests". Insert a headset into the PHF connector and plug the PHF earpiece
into your ear.
heard via the PHF earpiece.
Tests". Connect the RSM to the CE connector.
tone is heard via the RSM speaker.
Test". Place the internal earpiece close to your ear. Speak into the internal
MIC, and you will hear your voice via the internal earpiece.
Tests". Insert a headset into the PHF connector and plug the PHF earpiece
into your ear.
Test". Speak into the top microphone, and you will hear your voice via the
PHF earpiece.
Test". Speak into the PHF microphone, and you will hear your voice via the
PHF earpiece.
Tests". Connect the RSM to the CE connector.
4.2 - 13