Table of Contents
Advertisement
Before You Start Using BK-9
Installing the Music Rest
1.
Install the music rest as shown in the illustration.
NOTE
• When moving the BK-9, be sure to remove the music rest as a
safety precaution.
• Do not apply excessive force to the music rest.
• The music rest is not designed to accept the placement of
laptops or other heavy objects.
Placing the BK-9 on the Stand
If you place the BK-9 on a stand, you must use the KS-12 (sold separately).
NOTE
• When placing the BK-9 on the stand, be careful not to pinch
your fingers between the instrument and the stand.
• When lifting the BK-9 onto the stand, make sure to enlist the
help of at least one other person.
• Using the BK-9 with any other stand may produce an unstable
situation, possibly causing the instrument to fall or overturn,
and resulting in injury or damage.
• For details on how to assemble the stand, refer to the owner's
manual that accompanied the stand.
1.
Adjust the KS-12 Stand so that the width between the
holes is 842 mm.
2.
Place the BK-9 in the position shown in the illustration.
3.
Position the BK-9 front rubber feet "A" so they fit inside
the holes on the stand.
24
842 mm
Front side (keyboard)
A
Rear Rubber Feet
Rubber Feet
Rear panel side
NOTE
The height of the KS-12 can be set to 3 levels. Avoid selecting
the highest level (760 mm, 29-15/16 inches) for the BK-9.
Please set the KS-12 to its lowest (630 mm, 24-13/16 inches) or
medium (695 mm, 27-3/8 inches) height for the BK-9..
Turning the Power On/Off
Once everything is properly connected, be sure to follow the
procedure below to turn on their power. See "6. Before You Start
Using BK-9" (p. 20). If you turn on equipment in the wrong order,
you risk causing malfunction or equipment failure.
Turning the Power On
1.
Turn the [VOLUME] knob all the way to the left to
minimize the volume
NOTE
Before turning the BK-9 on/off, always be sure to turn the
volume down. Even with the volume turned down, you might
hear some sound when switching the BK-9 on/off.
However, this is normal and does not indicate a malfunction.
2.
Press the [POWER] switch to turn on the power.
On
Off
842 mm
A
Front
Rear Rubber Feet
Advertisement
Table of Contents
