Troubleshooting; Reset Procedure - Webasto BlueSky Operating Instructions Manual

6

Troubleshooting

Symptom Possible causes
Poor opening of the Pollution of rubber
roof seal.
Poor sliding of the Lack of grease on
roof the rails and guides
Roof does not slide
smoothly after
cleaning and greas-
ing
Roof does not open No Power
/ close
Broken fuse
Roof does not close
Motor does not op-
erate properly
Fig. 03: Emergency key in position for turning driving shaft
CAUTION
Uncontrolled rotation of emergency keys
around its own axis causing damage
Risk of injury and/or damage of components.
Do not operate roof electrically with the switch
X X
during manual ope ration using emergency key(s).
ATTENTION
Motor does not respond as expected
Improper functioning of roof.
Reset control system after operating roof
X X
manually.
Read chapter "Reset procedure".
X X
BlueSky
7
There is a minimum of 20 A available.
3 3
Solution
Clean seal with
X X
mild detergent
Clean and apply
X X
grea se to inside of
rails and guides
Contact supplier
X X
Check battery
X X
Replace fuse
X X
The system has been reset.
Close roof manu-
X X
ally by turning
driving shaft of
motor using the
emergency key
Reset roof
X X

Reset Procedure

Press and hold close button.
X X
The roof closes as far as possible.
Release close button.
X X
Press and hold close button.
X X
After approx. 10 seconds roof slides with small steps
until it is completely closed.
Motor produces a loud click sound.
Release close button.
X X
5