Table of Contents
Advertisement
6
Troubleshooting
Symptom
Possible causes
Poor opening of the
Pollution of rubber
roof
seal.
Poor sliding of the
Lack of grease on
roof
the rails and guides
Roof does not slide
smoothly after
cleaning and greas-
ing
Roof does not open
No Power
/ close
Broken fuse
Roof does not close
Motor does not
operate properly
Fig. 03:
Emergency key in position for turning driving shaft
CAUTION
Uncontrolled rotation of emergency keys
around its own axis causing damage
Risk of injury and/or damage of components.
Do not operate roof electrically with the switch
X
during manual ope ration using emergency key(s).
ATTENTION
Motor does not respond as expected
Improper functioning of roof.
Reset control system after operating roof
X
manually.
Read chapter "Reset procedure".
X
Marine Roofs 60 Series
7
There is a minimum of 20 A available.
3
Solution
Clean seal with
X
mild detergent
Clean and apply
X
grea se to inside of
rails and guides
Contact supplier
X
Check battery
X
Replace fuse
X
The system has been reset.
Close roof manu-
X
ally as described
below
8
Contact supplier
X
See „Annex" on page Annex-1.
Reset Procedure
Press and hold close button.
X
The roof closes as far as possible.
Release close button.
X
Press and hold close button.
X
After approx. 10 seconds roof slides with small steps
until it is completely closed.
Motor produces a loud click sound.
Release close button.
X
Declarations of con-
formity
EN-4
Advertisement
Table of Contents
