Network Settings; ① For Wired Lan (Ethernet) - Sharp PN-HM851 Software Setup Manual

Network Settings

① For wired LAN (Ethernet)
1. Connect the LAN cable to the LAN port on the monitor.
2. Press [CONTENT MENU] on the remote control to display the "CONTENT MENU" screen, and
select "Setup".
3. Select "Ethernet(LAN)".
The Android "Settings" – "Ethernet" screen appears.
4. Make sure that "Ethernet" is set to "ON".
5. Configure network settings as needed.
Setting a static (permanent) IP address
1) Select "IP settings".
2) Select the "Static" radio button.
3) Configure settings as appropriate for your network.
The static IP address cannot be saved unless "IP address", "Gateway", "Netmask", and
"DNS 1" are entered.
4) Select "CONNECT".
If the monitor is not connected to the network, "0.0.0.0" is displayed for the IP address.
9