Sharp PN-HM851 Software Setup Manual page 10

[POWER SAVE MODE setting]
Set "POWER SAVE MODE" to "OFF".
When "POWER SAVE MODE" is set to "ON", functions such as the following cannot be used.
 Scheduled playback using "Media Player", "SHARP e-Signage S Player A1" from the power "OFF"
(power standby) state.
 Reception of network distributed data/content and LAN commands in the power "OFF" (power
standby) state.
 Automatic update of the monitor firmware/Android system in the power "OFF" (power standby)
state.
MENU
1. Press on the center right side of the remote control to display the OSD menu.
2. Select "MONITER" – "POWER SAVE MODE".
3. Set "POWER SAVE MODE" to "OFF".
MENU
4. Press on the center right side of the remote control to close the OSD menu.
[Setting for PORTRAIT installation]
This setting can be configured to display the OSD menu and Android screen, including preinstalled
applications, in portrait orientation.
 The display of some applications may remain in landscape orientation even when this setting is
configured.
MENU
1. Press on the center right side of the remote control to display the OSD menu.
2. Select "MONITOR" – "PORTRAIT/LANDSCAPE INSTALL".
3. Select "PORTRAIT", and select "SET".
4. If the display is upside down, select "ROTATE 180°", and set "ON".
MENU
5. Press on the center right side of the remote control to close the OSD menu.
[Setting for FACE UP installation]
For a horizontal upward installation, configure the following setting.
MENU
1. Press on the center right side of the remote control to display the OSD menu.
2. Select "MONITOR" – "HORIZONTAL INSTALLATION", and select "FACE UP".
MENU
3. Press on the center right side of the remote control to close the OSD menu.
8