Vfo And Split (Spl) Operation; Cw Transmission - XIEGU G90 Operation Manual

VFO and Split (SPL) Operation

There are two independent VFOs inside the G90 transceiver. We can set different
frequencies and modes separately. With the SPL function, you can set up
independent TX and RX frequencies.
VFO setting:
1. Press the [A/B / A>B] button to switch between VFO-A and VFO-B.
2. Each VFO has independent operating frequency, mode and other settings.
Split frequency transceiver SPL operation:
1. Set the receiving frequency and mode (VFO-A) first;
2. Then setting the transmit frequency and mode (VFO-B);
3. Operate the second function of the [AGC/SPL] button.
You can make full use of VFOA/B to set different frequencies or modes, and switch between
two frequency points in real time.
22
VFO operation
SPL

CW Transmission

Operate with a straight key or paddles of common types.
Operation method:
1. Insert the key body (three-wire) plug into the KEY interface;
2. Press the [MODE] button to switch the mode to CW (or CWR);
3. Press the [Key] button and set the QSK ON to initiate CW transmission
4. Press the [Key] button again to set the QSK hold time if needed
Key button
Practice mode:
Remember that if the QSK is set to OFF, the side-tone will still be heard when
you use the key or paddles, but the transmitter will not send an RF signal.
The [KEY] button function contains
adjustment items that are commonly
used when doing CW communication:
CW SPEED
K-R/L
Iambic A/B
QSK ON/OFF
23