Removing And Installing Modules; Module Handling - MSB Technology The Select DAC User Manual

RS-232
XLR PREAMP
THE SELECT DAC SERIAL
INPUT
OUTPUT
RIGHTL EFT RIGHTL EFT
WORD
SYNC
RCA TOSLINK OUT
AMP CHASSIS
THE REFERENCE
DESIGNED
POWERBASE
AND
SERIAL
MADE
MSB
IN
12 VOLT
MSB
CALIFORNIA
TRIGGER
TECHNOLOGY
POWER 2 GROUNDING TERMINALS 105-130. 210-260 VAC
POWER 1

Removing and Installing Modules

Removal and installation of modules is a completely tool free process that is easily performed at
the back of the unit. Under the lower lip of each module is a lever arm. Simply pull the lever out and
away until it is perpendicular with the back of the unit. Then gently, but firmly, pull the module lip
and lever until the module releases and slide it out of the unit.
Analog output and analog input modules must be installed in a special fashion. When installing any
analog output or analog input module, you must remove the preamp output module and attach
the analog output or analog input module into the side connector of the larger preamp module and
then slide the connected pair into the back of the unit as one while making sure both levers are out
and tightened at the same time.

Module Handling

It is important that you refrain from touching the circuit board or rear connector of any input or
output module when removing or installing any input or output module from your DAC. When
handling these modules it is important that you only contact the metal case of the module or the
front edge of the module where the cam arm is located. Improper handling of your modules can
result in static shock and damage to the module or DAC.
Saving Menu and Startup Settings
When changing settings in the menu, use the enter button in the center of your volume wheel on
the remote or the circle on the DAC faceplate to confirm settings in the DAC menu. After you have
made your changes in the DAC menu, use the menu button to exit the DAC menu completely to save
the changes you have made in the DAC menu.
The DAC will not save any of your settings until you exit the menu.
The "Action Buttons" on your remote change certain settings on your DAC without navigating the
DAC menu (Phase Invert and Video Mode). However, these settings reset every time the DAC is reset
or powered off. If you would like these settings to persist through resets or power offs, you simply
have to choose the action button setting that you wish to be default and then enter and exit the DAC
menu by double clicking the Menu button on your remote or DAC faceplate.
If at any point the DAC seems to be improperly setup or you want to start fresh with your settings
and functions, there is a "Reset" option near the end of the DAC menu. Simply select this and
confirm "YES" before closing the DAC menu and restarting the unit.