Production Data - Elis FLONET FN20xx.1 Series Design, Assembly And Service Manual

ELIS PLZEŇ a. s.

7.1.7. Production data

The first three menu items, i.e. Production Data, Serial Number and Software, give basic information about
the electromagnetic flowmeter and as such cannot be edited. The other items, i.e. Sensor Constants,
Excitation Frequency, Suppressed Flow Rate, Language, Sensor Number, Sensor DN, Errors, Dose
Correction, Flow Direction and Base Frequency can be changed by the user unless the flowmeter is certified
and used as an invoicing meter; in such cases the sensor constants, excitation frequency and suppressed
flow rate are protected against unauthorised modification.
Menu: Production data, press the
Production date
Serial number
Software
Sensor constants
Excitation freq.
Suppressed flow
Language
Sensor number
Sensor DN
Errors
Dose correction
Flow direction
Base frequency
The two-line display will always show two selected menu items. To browse through the menu items, press
repeatedly the (direction downwards) and
key.
Menu: Production data, press the
The display will read "Production Date dd mm yyyy". This information cannot be edited. To return to the
Production data menu, press any key, for example the
Menu: Production data, press the
The display will read "Serial Number xxxxxrr". This information cannot be edited. To return to the Production
data menu, press any key, for example the
Menu: Production data, press the
The display will read "Software v.xxxxx/xx". This information cannot be edited. To return to the Production
data menu, press any key, for example the
Menu: Production data, press the
Constant 1
Constant 2
To browse through the menu items, use the
desired item and press the
this value, use the
using the and keys, respectively. The sensor constants shall be set at the values indicated on the
sensor nameplate. Any difference in the values of constants results in the incorrect calibration of flowmeter.
ELIS PLZEŇ a. s., Luční 425/15, 301 00 Plzeň, Czech Republic, Phone: +420/377 517 711, Fax: +420/377 517 722
Design, Assembly and Service Manual
Electromagnetic flowmeter FLONET FN20xx.1
key.
key / Production date, press the
key / Serial number, press the
key. The menu will reappear on the display.
key / Software, press the
key. The menu will reappear on the display.
key / Sensor constants, press the
key. The constant value will appear on the display. Should you wish to change
key to place the cursor under the selected figure and increase/decrease the same
keys (upwards). To select a particular menu item, press the
key. The menu will reappear on the display.
key
key
(direction downwards) and
Page 42 of 69
key
key
key (upwards). Select the
Es90420K/c