Uploading A Parameter Set To An Lme7 - Siemens LME7 Series Technical Instructions

LME Series

Uploading a Parameter Set to an LME7

The following steps outline the procedure for uploading parameter sets from a PC to an LME7.
1. Ensure that the ACS410 software is open, and the PC is connected to the LME7 at the
service or OEM level. See previous sections if necessary.
2. Click on the "Backup / Restore" tab. A list of stored parameter sets will display on the
screen. Select the parameter set to be uploaded into the LME7 and click on "Restore" in the
lower-right corner. This file will overwrite the parameter set on the LME7 and will determine
the behavior of the LME7. Be sure that the correct file is selected.
3. A prompt will appear asking to confirm that the proper file was selected. Click "Yes". After
about a minute, a box should appear stating that the upload was successful. If an error
message is returned, see below for the cause of the error:
Burner ID: The burner ID of the data set stored on the PC does not match the burner ID of the
LME7. View the burner ID (parameter 113) of the stored parameter set and ensure that it
matches the burner ID displayed by parameter 113 on the LME7.
Note: This only applies if the burner ID of the LME7 has been modified from its default
value, which is undefined (all dashes). You can always overwrite the parameters on an
LME7 with an undefined burner ID.
Incompatible parameter sets: The current software version of the LME7 is not compatible with
the software version of the parameter set stored on the PC.
Different types of units: It is not possible to copy the parameter set from one version of LME7
to another version of LME7. For example, a parameter set saved from an LME71.111A1 burner
control cannot be restored into an LME73.811A1 burner control - it can only be restored into
another LME71.111A1 burner control.
SCC Inc. Page 5
Technical Instructions
Document No. LME-1000
Section 9