Table of Contents
Advertisement
Repair
3. Once the pulley is removed, the bearing assembly
on that side can be removed using the 6mm hex
key.
4. Remove the bearing housing from the Drum Access
Panel using the 13mm socket or wrench.
5. Insert new drive bearing assembly into the drum
housing and tighten the bolts. Insert the drive shaft
key into the key slot. Tighten lock nut onto shaft.
6. Assemble the lower pulley onto the shaft.
7. Slide cutter drum onto shaft.
8. Install new door bearing onto the Drum Access
Panel with the 4 bolts. Assemble the Drum Access
Panel onto the unit.
9. Replace belt and belt guard (see page 25).
30
Bearing Replacement (Pro
Models)
Tools required:
1. 7/16" socket or wrench
2. 1/2" socket or wrench
3. 1" open-end wrench
4. 3/16" Hex Key
5. 5/32" Hex Key
6. 1/8" Hex Key
To avoid injury from unexpected start up, disconnect
spark plug wire before you service your unit.
1. Tip the machine over towards the FRONT and place
the 1" wrench over the hex shaft to prevent it from
rotating.
2. Remove the center screw using the 1/2" socket.
3A5578C
Advertisement
Table of Contents
