Table of Contents
Advertisement
Operation
Do not start machine while drum is in contact with the
ground. Doing so can cause the operator to lose
control of the machine, resulting in property damage
and/or personal injury.
Machine Start Up
Before starting engine, perform the following:
•
Read and understand engine manual.
•
Make sure all guards are in place and secure.
•
Make sure all mechanical fasteners are secure.
•
Inspect for damage to engine and other exterior
surfaces.
•
Use correct cutters for each job. Make sure drum is
balanced and the correct number, size and type of
cutter wheels are being used. Make sure Drum
Access Panel is locked and secured.
•
Inspect work area to locate any pipes, columns,
deck inserts, or other objects protruding from work
surface. Avoid these objects during operation.
•
Open the fuel shut off on the gas tank and then
place the throttle lever at the "fast idle" position.
•
Move the choke to closed.
•
Set the engine power switch to ON.
•
Pull starter cord.
•
After the engine starts, move choke to open.
•
Set throttle to desired setting.
3A5578C
If the Engine Does Not Start
•
Check engine for proper gas level.
•
Check the spark plug. Make sure socket areas are
clean and clear of debris, and the proper gap is set.
Replace if needed.
•
Turn the Engine Power Switch on the front of the
engine to "On".
•
Engine may have tilted backwards. If so, allow oil to
drain after removing spark plug.
•
If engine still does not start, refer to the engine
manual.
•
The engine will not start without the Corded Engine
Kill Clip securely in place.
NOTE: The machine will still move with the engine off
because there are no wheel brakes.
DCS Models
Turn DCS Control Power Switch ON (Engine will not start
if power switch is off). See DCS Control (DCS Models
only), page 11, for help setting up the DCS Control.
Operation
15
Advertisement
Table of Contents
