Operation; Getting Started; Chapter & Page Selection Methods; Menus Option - Raymarine ST290 Owner's Handbook Manual

81183_2 S2.book Page 2 Tuesday, May 6, 2003 8:39 AM
2-2-2
chapter. These diagrams assume that a full range of data is available (i.e.
that all necessary transducers are fitted).
If you want to use a different operating profile, or edit a custom profile,
refer to Section 7, Chapter 2, Setting Up Graphic Displays.

2.2 Operation

Getting started

At power up, each instrument is in Normal mode, using the operating
profile that was in use when it was last switched off.
Note: When an instrument is switched on for the first time after installa-
tion, an operating profile must first be selected. See Section 2, Chapter 1
for details.
Chapter & page selection methods
The manner in which chapters and pages are selected for viewing de-
pends on which selection option you are using (see Introduction above).

Menus option

Selecting chapters
When you are using the menu selection option, use the following
procedure to select a new chapter:
1. Press the
is displayed (Figure 2-2 ).
Figure 2-2: Chapter menu
Note: The Chapter Select mode will time out to Normal operation after
5 seconds without any button presses.
Section 2: Using Digital Instruments
button to enter Chapter Select mode. The chapter menu
D5671-1
ST290 Instrument System Owner's Handbook