Wind, Speed & Depth Transducers; Cable Lengths; Wind - Raymarine ST290 Owner's Handbook Manual

81183_2 S6.book Page 11 Wednesday, May 7, 2003 11:27 AM
Chapter 1: Preparing for Installation
•
•
Wind, Speed & Depth transducers

Cable lengths

The Wind, Speed and Depth transducer types connect to SeaTALK
an associated Pod. The transducers are supplied with fitted cables, as
follows:
•
•

Wind

The Wind transducer is supplied with a junction box and a set of spade
terminals. The intended location for the wind transducer must:
•
•
•
Figure 1-6: Wind Transducer dimensions
ST290 Instrument System Owner's Handbook
Each product is at least 20 in (500 mm) from radio receiving equip-
ment.
There is reasonable rear access for installation and servicing.
Wind: 164 ft (50 m)
Depth/Speed: 45 ft (13.7 m)
Be as high as possible and away from any equipment which may
shield the transducer or otherwise disturb the air flow.
Allow reasonable access for installation and servicing.
Provide a horizontal mounting surface. If a surface (e.g. mast top) is
otherwise suitable but not horizontal, make up a suitable wedged
packing piece to provide the necessary horizontal surface.
12.2 in (310 mm)
2.5 in (63.5 mm)
1.25 in
(31.75 mm)
33.5 in (850 mm)
6-1-11
2
via
D5602-1