Makita EB7650TH Technical Information page 4

[3] DISASSEMBLY/ASSEMBLY
[3]-1. Warning
・There is a risk of a burn injury immediately after the engine is stopped. So wait until the engine has completely cooled
before performing the work.
・Completely remove all fuel from the inside of Fuel tank and Carburetor before performing the work. [No open flames]
・Remove the engine oil before performing the work.
・Perform the work on a solid workbench in a place where dust, dirt, etc. will not enter inside.
・Remember how and where the parts were assembled when disassembling the product and take care not to make a mistake
when assembling the product.
Prepare boxes so that you can store the parts in groups when disassembling the product.
・Handle the removed parts carefully and clean and wash them properly.
・If a bolt or screw cannot be loosened, do not apply excessive force. Use an impact driver or similar tool.
・Be sure to tighten bolts and screws to the specified tightening torque values.
・After assembling the main parts, turn the engine by hand to check that there is no abnormality or looseness.
[3]-2. Blower Section (Band Completes L and R, Frame and Fan)
Disassembly
(1) Remove Band completes L and R and Hip belt. Remove each of the fixing parts as shown in Fig. 1
Fig. 1
Pull out the band as shown above.
Position the buckle vertically
and then remove it.
Makita Corporation
.
Turn the center of Lock rivet with
a Phillips screwdriver to loosen it a
little and then remove it.
P 4/ 35