Makita EB7650TH Technical Information page 16

Assembly
(1) Assemble the parts by reversing the disassembly procedure.
(2) Rotate Pulley to turn Crankshaft clockwise to align the alignment mark of two lines (a) on Flywheel so that they are parallel with the
surface of Crankcase. "N" on the north pole of Flywheel will be positioned directly below the surface of Crankcase. (Fig. 31)
Fig. 31
(a)
Flywheel
"N" on the north
pole of Flywheel
(3) Align the alignment mark on Camgear (b1) and that of Crankcase (b2), then assemble them and then attach Camgear cover. (Fig. 32)
Fig. 32
・Please note that the engine speed will not increase if even one of the gear teeth is not aligned.
・Install the gasket so that the convex surface is facing the engine side. (Fig. 33)
Fig. 33
Crankcase
(a)
Ignition coil
(b1)
(b2)
When turning Camgear by
hand, rotate Pulley in the
direction of the arrow.
・Install so that the convex surface
is facing the engine side.
Cross section of gasket
Makita Corporation
P 16/ 35