Makita EB7650TH Technical Information page 11

P 11/ 35
EB7650WH
Disassembly
(1) Loosen six 4x18 Tapping screws and then remove Arm cover.
(2) Loosen M5x25 Hex socket head bolt and remove Throttle lever (a). (Fig. 17)
Fig. 17
(a)
Wave washer 20
(3) Remove the head of Control cable (b) from Throttle lever (a), then disconnect the connector (c) of Stop switch wire and then pull out
Control cable (b), Lead unit, and Corrugated tube (d). (Fig. 18)
Fig. 18
Remove (b).
Pull out
(d).
Disconnect (c).
(4) Loosen M6x25 Hex socket head bolt and then remove Arm base (e).
(5) Disassemble Arm base (e) and Arm base holder (f) by removing one of two E-4 Stop rings (g) and then pushing out Rod 6 (h) from there.
(Fig. 19)
Fig. 19
(e)
Two rubber sleeves 6
(g)
(h)
(g)
Two torsion springs 21
(f)
Makita Corporation