[3]-9. Crankcase
(1) Refer to "[3]-2. Blower Section (Band Completes L and R, Frame and Fan)" (page 4) and then separate the engine section from
Frame.
(2) Remove the six M6x25 Hex socket head bolts from Front volute case and then detach the engine block.
When assembling, tighten the bolts in the order shown in Fig. 50.
Fig. 50
1
7
4
5
(3) Remove three M6x18 Hex socket head bolts (a) and then remove Muffler gasket (b) and Exhaust port spacer (c). (Fig. 51)
Fig. 51
(c)
(b)
(4) Loosen two M5x25 Hex socket head bolts and one M5x14 Hex socket head bolt (total of three bolts) and remove Insulator complete (d).
(Fig. 52) For removing tubes, refer to "[3]-6. Carburetor" (page 18).
Fig. 52
(5) Remove Pulley, Rocker cover complete, and Cylinder head complete.
3
2
6
Muffler
(a)
(d)
Makita Corporation
P 23/ 35