Applicable Standards - ABB IRC5 with T10 Operating Manual

1 Safety

1.2 Applicable standards

1.2 Applicable standards
The listed standards are valid at the time of the release of this document. Phased
out or replaced standards are removed from the list when needed.
Standards, EN ISO
The product is designed in accordance with the requirements of:
Standard
EN ISO 12100
EN ISO 13849-1
EN ISO 13850
EN ISO 10218-1
EN ISO 9787
EN ISO 9283
EN ISO 14644-1
EN ISO 13732-1
EN IEC 61000-6-4
(option 129-1)
EN IEC 61000-6-2
EN IEC 60974-1
EN IEC 60974-10
EN IEC 60204-1
IEC 60529
i
ii
European standards
Standard
EN 614-1
EN 574
Continues on next page
12
Note
Description
Safety of machinery - General principles for design - Risk as-
sessment and risk reduction
Safety of machinery, safety related parts of control systems -
Part 1: General principles for design
Safety of machinery - Emergency stop - Principles for design
Robots for industrial environments - Safety requirements -Part
1 Robot
Robots and robotic devices -- Coordinate systems and motion
nomenclatures
Manipulating industrial robots, performance criteria, and related
test methods
i Classification of air cleanliness
Ergonomics of the thermal environment - Part 1
EMC, Generic emission
EMC, Generic immunity
Arc welding equipment - Part 1: Welding power sources
ii
ii Arc welding equipment - Part 10: EMC requirements
Safety of machinery - Electrical equipment of machines - Part
1 General requirements
Degrees of protection provided by enclosures (IP code)
Only robots with protection Clean Room.
Only valid for arc welding robots. Replaces EN IEC 61000-6-4 for arc welding robots.
Description
Safety of machinery - Ergonomic design principles - Part 1:
Terminology and general principles
Safety of machinery - Two-hand control devices - Functional
aspects - Principles for design
© Copyright 2017 ABB. All rights reserved.
Operating manual - IRC5 with T10
3HAC050943-001 Revision: C