Warning Indicators And Messages - Sony DCR-IP210 Operating Instructions Manual

Warning indicators and messages

If indicators and messages appear on the LCD screen, check the following:
See the page in parentheses "( )" for more information.
Warning indicators
100-0001 Warning indicator as to file
Slow flashing:
•The file is corrupted.
•The file is unreadable.
•You are trying to carry out MEMORY MIX
function on a moving picture (p. 125).
C:21:00 Self-diagnosis display (p. 192)
E The battery is dead or nearly dead
Slow flashing:
•The battery is nearly dead.
Depending on operational, environmental or
battery conditions the E indicator may flash,
even if there are approximately five to 10
minutes remaining.
% Moisture condensation has occurred*
Fast flashing:
•Eject the cassette, turn off your camcorder,
and leave it for about one hour with the
cassette compartment open (p. 201).
Warning indicator as to micro Cassette
Memory*
Slow flashing:
•Eject the cassette, and insert it again. If even
then the indicator flashes, the micro Cassette
Memory of the cassette may be faulty.
Fast flashing:
•The micro Cassette Memory of your
camcorder may be faulty.
Warning indicator as to "Memory Stick"
Slow flashing:
•No "Memory Stick" is inserted.
Fast flashing:
•The image cannot be recorded on "Memory
Stick."
Warning indicator as to "Memory Stick"
formatting*
Fast flashing:
•The "Memory Stick" data is corrupted
(p. 100).
•"Memory Stick" is not formatted correctly
(p. 182).
100–0001 C:21:00
Warning indicator as to incompatible
"Memory Stick"*
Slow flashing:
•An incompatible "Memory Stick" is inserted.
Q Warning indicator as to tape
Slow flashing:
•The tape is near the end.
•No cassette is inserted.*
•The write-protect tab on the cassette is out
(red) (p. 25).*
Fast flashing:
•The tape has run out.*
q Z Warning indicator as to a cleaning
cassette (DCR-IP220 only)
Slow flashing:
•A cleaning cassette is inserted in MEMORY/
NETWORK mode (p. 202).
Z You need to eject the cassette*
Slow flashing:
•The write-protect tab on the cassette is out
(red) (p. 25).
Fast flashing:
•Moisture condensation has occurred (p. 201).
•The tape has run out.
•The self-diagnosis display function is
activated (p. 192).
- The image is protected*
Slow flashing:
•The image is protected (p. 146).
Warning indicator as to the flash
Slow flashing:
•During charging.
Fast flashing:
•The self-diagnosis display function is
activated (p. 192).*
•There is something wrong with the flash.
Warning indicator as to recording of
still image
Slow image:
•The still image cannot be recorded on a
"Memory Stick" (p. 47).
* You hear the melody or beep sound.
193