Charging The Battery Pack - Sony DCR-IP210 Operating Instructions Manual

Step 1 Preparing the power supply

Charging the battery pack

Charge the battery pack before using your camcorder.
Your camcorder operates only with the "InfoLITHIUM" battery pack (NP-FF70).
See page 196 for details of the "InfoLITHIUM" battery pack.
(1) Open the jack cover and connect the supplied AC power adaptor to the DC IN
(2) Connect the power cord to the AC power adaptor.
(3) Connect the power cord to a wall outlet.
(4) Set the POWER switch to (CHG) OFF.
2
3
To a wall outlet
After charging the battery pack
Disconnect the AC power adaptor from the DC IN jack on your camcorder.
18
jack on your camcorder with the plug's v mark facing down.
The battery CHG lamp lights up when the charge begins. After charging is
completed, the battery CHG lamp goes off (full charge).
Battery CHG lamp
4
POWER
1